The Lumenier LUX flight controller provides high quality flight control using
the powerful F3 processor along with top of the line hardware. Unleash the
capabilities of your FPV Racing Quadcopter with the Lumenier LUX Flight
Controller. Achieve gyro refresh rates up to 8kHz (high speed SPI) using
popular Betaflight and Raceflight firmware along with ultra low looptimes. The
LUX comes with CleanFlight pre-installed.
The Lumenier LUX is a very low profile board allowing it to be mounted in a
variety of ways. The board also comes with a set of pin headers you can
optionaly solder on. Alternatively, signal wires can be soldered directly to the
pads to save on size and weight. The LUX supports PPM or Serial RX (including
Futaba, FrSky, S.BUS). A signal inverter is already included for S.BUS.
Please note: Baseflight firmware is not supported, and PWM input for
individual channels is not supported.
Hardware Features
USB Conflict resolution - Hardware inversion, SBUS or telemetry can
be used on any of the 3 available hardware serial ports. USB will not
interfere with peripherals.
High Speed SPI 8kHz Gyro
MPU interrupt connected to F3, allowing the F3 to know immediately when
fresh data is available.
Dedicated Boot button for easy firmware flashing.
Reinforced solder pads for trouble-free direct soldering.
Extremely low profile design.
Recessed, sideways pin headers. Also enables soldering of all wires directly
to pads without use of any pin headers.
Integrated FRSky RSSI Filter (RC filter).
Input voltage 6v to 24v. Power the board directly from flight pack up to 6S
(on 'BAT' pad only!).
VIN + VBAT merged - A single wire to power the board will provide voltage
input and Telemetry/OSD voltage data.
Filtered voltage output - output 5v 1A (and 3.3v where applicable) to power
peripherals such as GPS, RX, BLACKBOX, OSD. 5v/3.3v RX selectable.
Software/Hardware Features
Cleanflight support (RACE target).
BLHeli flashing supported by hardware
Raceflight ready
Betaflight ready
Specifications
STM32F303RCT6(256kB flash) 32-bit processor
MPU6500 Gyro/Accelerometer
High quality, gold plated PCB
Highest quality components, individually sourced to meet Lumenier standards